ON-VEHICLE INSPECTION PROCEDURE 1. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (see page ). 2. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED) (a) Perform a diagnostic system check (see page ). 3. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED) (a) Replace the center airbag sensor. CAUTION: For removal and installation procedures of the center airbag sensor, be sure to follow the correct procedure. HINT: The center airbag sensor should be replaced after any of the airbags has deployed, as it has been subjected to the impact. |
Toyota Tundra Service Manual > Vehicle Stability Control System: ABS Warning Light does not Come ON
DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibrati ...