REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ). 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 3. REMOVE ROOF HEADLINING ASSEMBLY HINT: Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (for CrewMax) (see page ). 4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY (a) Disconnect the connector. NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness. (b) Remove the 10 bolts and curtain shield airbag. |
Toyota Tundra Service Manual > Shift Lever Assembly(for Floor Shift Type): Reassembly
REASSEMBLY PROCEDURE 1. INSTALL SHIFT LOCK CONTROL ECU (a) Attach the 3 claws to install the shift lock control ECU to the shift lever assembly. (b) Connect the shift lock solenoid connector. 2. INSTALL POSITION INDICATOR LED (a) Attach the claw to install the position indicator LED to the lower pos ...