Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

3. REMOVE FRONT DOOR SCUFF PLATE LH

Click here

4. REMOVE COWL SIDE TRIM BOARD LH

Click here

5. REMOVE INSTRUMENT SIDE PANEL LH

Click here

6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Click here

7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

CAUTION:

When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

(c) Remove the 4 bolts and remove the instrument panel airbag.

(d) Detach the 2 claws and disconnect the DLC3.

(e) Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.

    On-vehicle Inspection

    Front Airbag Sensor

    See More:

    Toyota Tundra Service Manual > Headlight Dimmer Switch: Installation
    INSTALLATION PROCEDURE 1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY (a) Install the headlight dimmer switch assembly to the steering column, making sure that the stopper protrusions and cutout parts align. Text in Illustration *A for Manual Tilt, for Manual Tilt and Manual Telescopic Steering Column ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0345