ON-VEHICLE INSPECTION PROCEDURE 1. CHECK FRONT SEAT AIRBAG ASSEMBLY LH (VEHICLE NOT INVOLVED IN COLLISION)
(b) With the front seat airbag assembly LH installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat with a new one: Cuts, minute cracks or marked discoloration on the front seatback around the front seat airbag assembly LH. 2. CHECK FRONT SEAT AIRBAG ASSEMBLY LH (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(b) With the front seat airbag assembly LH removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat airbag assembly LH with a new one:
|
Toyota Tundra Service Manual > Rear Axle Shaft: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR AXLE SHAFT SNAP RING (a) Using a snap ring expander, remove the snap ring. 2. REMOVE REAR AXLE SHAFT (a) Using SST and a press, press out the rear axle shaft. SST: 09521-25011 SST: 09521-60010 (b) Remove the rear axle bearing inner retainer from the axle hub. (c) ...