REMOVAL PROCEDURE 1. REMOVE PULL TOP ANTENNA POLE SUB-ASSEMBLY (See page 2. PRECAUTION NOTICE: After
turning the ignition switch off, waiting time may be required before
disconnecting the cable from the battery terminal. Therefore, make sure
to read the disconnecting the cable from the battery terminal notice
before proceeding with work (See page 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
4. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (a) for Column Shift Type: (See page (b) for Floor Shift Type: (See page
5. REMOVE ANTENNA ORNAMENT ![]() (a) Remove the antenna ornament as shown in the illustration. 6. REMOVE SIDE STEP ASSEMBLY RH (w/ Side Step)
7. REMOVE FRONT FENDER MUDGUARD RH (w/ Front Fender Mudguard) 8. REMOVE FRONT FENDER LINER RH 9. REMOVE FENDER ANTENNA ASSEMBLY
(b) Remove the bolt and detach the 5 clamps.
|
Toyota Tundra Service Manual > Can Communication System: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT PRECAUTIONS WHEN TROUBLESHOOTING NOTICE: Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output. If the CAN communication system ...