INSTALLATION PROCEDURE 1. INSTALL SEAT POSITION AIRBAG SENSOR
(b) Using a T30 "TORX" socket wrench, tighten the "TORX" screw to install the seat position airbag sensor. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} (c) Make sure that the clearance between the seat position airbag sensor and the seat rail is within 0.6 to 1.4 mm (0.0236 to 0.0551 in.). (d) Connect the connector. (e) Check that there is no looseness in the installation parts of the seat position airbag sensor. 2. INSTALL FRONT SEAT CUSHION SHIELD LH (for Manual Seat)
3. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)
4. INSTALL FRONT SEAT ASSEMBLY LH (a) for Manual Seat: (See page ) (b) for Power Seat: (See page ) 5. CHECK SRS WARNING LIGHT (See page ) |
Toyota Tundra Service Manual > Trailer Brake Control Ecu: Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: When replacing the brake control with bracket relay, the stored gain value is reset. Before replacing the brake control with bracket relay, record the set gain value. HINT: After replacing the brake control with bracket relay, the gain value is set to 5.0 (ini ...