REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ). NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page ). 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 3. REMOVE LOWER NO. 3 STEERING WHEEL COVER
4. REMOVE LOWER NO. 2 STEERING WHEEL COVER
5. REMOVE STEERING PAD CAUTION: When storing the steering pad, keep the airbag deployment side facing upward. (a) Check that the ignition switch is off. (b) Check that the cable is disconnected from the negative (-) battery terminal. NOTICE: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(d) Pull the steering pad toward you.
(f) Using a screwdriver, release the 2 airbag connector locks. HINT: Tape the screwdriver tip before use. Text in Illustration
(g) Disconnect the 2 airbag connectors and remove the steering pad as shown in the illustration. NOTICE: When disconnecting any airbag connector, take care not to damage the airbag wire harness. |
Toyota Tundra Service Manual > Front Passenger Airbag Assembly: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK FRONT PASSENGER AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (see page ). (b) With the front passenger airbag installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace t ...