Components COMPONENTS ILLUSTRATION
Inspection INSPECTION PROCEDURE 1. INSPECT HOOD LOCK ASSEMBLY (HOOD COURTESY SWITCH) Text in Illustration
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the results are not as specified, replace the hood lock assembly (hood courtesy switch). Installation INSTALLATION PROCEDURE 1. INSTALL HOOD LOCK ASSEMBLY (a) Apply MP grease to the sliding areas of the hood lock assembly. (b) Connect the hood lock control cable assembly. (c) Install the hood lock assembly. (d) Install the 3 bolts. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} (e) Install a new hood lock nut cap. (f) Connect the connector. (g) Attach the clamp. 2. INSTALL RADIATOR GRILLE SUB-ASSEMBLY
Removal REMOVAL PROCEDURE 1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY
2. REMOVE HOOD LOCK ASSEMBLY
(b) Detach the clamp.
(e) Remove the hood lock assembly. (f) Disconnect the hood lock control cable assembly. |
Toyota Tundra Service Manual > Touch Select 2-4 And High-low System: Automatic Disconnecting Differential Motor Control Circuit Open (P17A0,P17A1)
DESCRIPTION This DTC is detected when an open circuit or short to ground in the A.D.D. shift motor drive circuit is detected. DTC Code DTC Detection Condition Diagnosis Condition Malfunction Status Malfunction Time Other Trouble Area P17A0 Ignition switch ON (when not switching between 2WD and 4H) O ...