Toyota Tundra Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart.

Click here

PROCEDURE

1. INSTALL GLASS BREAKAGE SENSOR ECU

(a) Install the glass breakage sensor ECU with the nut.

Torque:

7.6 N·m {77 kgf·cm, 67 in·lbf}

(b) Install the junction block with the 2 nuts.

(c) Connect each connector.

2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Click here

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

(a) for Column Shift Type:

Click here

(b) for Floor Shift Type:

Click here

4. INSTALL INSTRUMENT SIDE PANEL LH

(a) for Column Shift Type:

Click here

(b) for Floor Shift Type:

Click here

5. INSTALL COWL SIDE TRIM BOARD LH

(a) for Double Cab:

Click here

(b) for CrewMax:

Click here

6. INSTALL FRONT DOOR SCUFF PLATE LH

(a) for Double Cab:

Click here

(b) for CrewMax:

Click here

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

8. CHECK SRS WARNING LIGHT

Click here

    Components

    Removal

    See More:

    Toyota Tundra Service Manual > Airbag System: Curtain Shield Airbag Sensor (RH) (B1630,B1635)
    DESCRIPTION The No. 2 side airbag sensor assembly LH or RH consists of a lateral deceleration sensor, etc. If the airbag sensor assembly receives signals from the lateral deceleration sensor, it determines whether the SRS should be activated. DTC B1630 or B1635 is stored when a malfunction is detect ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0336