INSTALLATION PROCEDURE 1. INSTALL STEREO COMPONENT TUNER ASSEMBLY (w/ Satellite Radio) 2. INSTALL NO. 2 RADIO RECEIVER BRACKET (a) w/o Satellite Radio: Install the No. 2 radio receiver bracket with the 3 bolts. Torque: 3.5 N·m {36 kgf·cm, 31 in·lbf} (b) w/ Satellite Radio: Install the No. 2 radio receiver bracket with the 5 bolts. Torque: 3.5 N·m {36 kgf·cm, 31 in·lbf} 3. INSTALL NO. 1 RADIO RECEIVER BRACKET (a) w/o Satellite Radio: Install the No. 1 radio receiver bracket with the 3 bolts. Torque: 3.5 N·m {36 kgf·cm, 31 in·lbf} (b) w/ Satellite Radio: Install the No. 1 radio receiver bracket with the 5 bolts. Torque: 3.5 N·m {36 kgf·cm, 31 in·lbf} 4. INSTALL NO. 1 NAVIGATION WIRE (w/ Satellite Radio) 5. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY (a) Connect each connector. (b) Insert the radio and display receiver assembly with bracket and attach the 2 guides and 3 clips on its backside. NOTICE: When inserting the radio receiver, do not press its knobs. (c) Install the radio and display receiver assembly with bracket with the 4 bolts. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} 6. INSTALL AIR CONDITIONING CONTROL ASSEMBLY 7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY 8. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY 9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
|
Toyota Tundra Service Manual > Steering Angle Sensor: Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ). 2. ...