INSPECTION PROCEDURE 1. INSPECT REAR NO. 1 SPEAKER ASSEMBLY (for Standard) ![]() (a) Measure the resistance according to the value(s) in the table below. Standard resistance:
If the result is not as specified, replace the rear No. 1 speaker assembly. Text in Illustration
2. INSPECT REAR NO. 1 SPEAKER ASSEMBLY (for 12 Speakers) ![]() (a) Measure the resistance according to the value(s) in the table below. Standard resistance:
If the result is not as specified, replace the rear No. 1 speaker assembly. Text in Illustration
3. INSPECT REAR NO. 2 SPEAKER ASSEMBLY (a) When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears. OK: Malfunction disappears. HINT:
|
Toyota Tundra Service Manual > Rear View Monitor System(for Navigation Receiver Type): Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Rear View Monitor System DTC Code Detection Item See page C1622 Open or Short Circuit in Back Camera Signal ...