DESCRIPTION
WIRING DIAGRAM PROCEDURE
(a) Remove the front power window regulator motor assembly LH (See page ). (b) Inspect the front power window regulator motor assembly LH (See page ).
(a) Disconnect the N2 master switch connector. (b) Disconnect the N3 motor connector. (c) Measure the resistance according to the value(s) in the table below. Standard Resistance:
(a) Remove the power window regulator master switch assembly (See page ). (b) Inspect the power window regulator master switch assembly (See page ).
|
Toyota Tundra Service Manual > Pre-collision System: ECU Power Source Circuit
DESCRIPTION This circuit supplies power to the millimeter wave radar sensor assembly when the ignition switch is ON. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedure. PROCEDURE 1. CHECK MILLIMETE ...