Toyota Tundra Service Manual: Rear Door Speaker(for Double Cab)

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR NO. 1 SPEAKER ASSEMBLY (for Standard)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Always

3.2 to 4.8 Ω

If the result is not as specified, replace the rear No. 1 speaker assembly.

Text in Illustration

*a

Component without harness connected

(Rear No. 1 Speaker Assembly)

2. INSPECT REAR NO. 1 SPEAKER ASSEMBLY (for 7 Speakers)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Always

2 Ω

If the result is not as specified, replace the rear No. 1 speaker assembly.

Text in Illustration

*a

Component without harness connected

(Rear No. 1 Speaker Assembly)

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR NO. 1 SPEAKER ASSEMBLY

(a) Connect the connector.

Text in Illustration

*A

for Standard

*B

for 7 Speakers

(b) Install the rear No. 1 speaker assembly with the 3 screws.

NOTICE:

Do not touch the cone part of the speaker.

HINT:

Install the screws in the order shown in the illustration.

2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

3. INSTALL REAR DOOR ARMREST COVER LH

4. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH

5. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

6. INSTALL REAR DOOR FRAME GARNISH LH

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE REAR DOOR FRAME GARNISH LH

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

3. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH

4. REMOVE REAR DOOR ARMREST COVER LH

5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

6. REMOVE REAR NO. 1 SPEAKER ASSEMBLY

(a) Remove the 3 screws.

Text in Illustration

*A

for Standard

*B

for 7 Speakers

NOTICE:

Do not touch the cone part of the speaker.

(b) Disconnect the connector and remove the rear No. 1 speaker assembly.

    Removal

    Satellite Radio Antenna

    See More:

    Toyota Tundra Service Manual > Brake Master Cylinder: Installation
    INSTALLATION PROCEDURE 1. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY (a) Apply lithium soap base glycol grease to the entire circumference of a new brake master cylinder seal. (b) Install the brake master cylinder seal onto the brake master cylinder. (c) Install the brake master cylinder with 2 new ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0345