INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Attach the 6 guides and 2 claws to install the steering pad switch assembly. (b) Install the 4 screws. (c) Connect each connector. 2. INSTALL STEERING PAD Click here 3. INSTALL LOWER NO. 3 STEERING WHEEL COVER Click here 4. INSTALL LOWER NO. 2 STEERING WHEEL COVER Click here 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 6. INSPECT STEERING PAD Click here 7. CHECK SRS WARNING LIGHT Click here |
Toyota Tundra Owners Manual > Steps to take in an
emergency: If a warning light turns on
or a warning buzzer
sounds
Calmly perform the following actions if any of the warning lights comes on or flashes. If a light comes on or flashes, but then goes off, this does not necessarily indicate a malfunction in the system. However, if this continues to occur, have the vehicle inspected by your Toyota dealer. Warning li ...
