Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

3. REMOVE LOWER NO. 2 STEERING WHEEL COVER

Click here

4. REMOVE LOWER NO. 3 STEERING WHEEL COVER

Click here

5. REMOVE STEERING PAD

Click here

6. REMOVE STEERING PAD SWITCH ASSEMBLY

(a) Disconnect each connector.

Screw

Connector

(b) Remove the 4 screws.

(c) Detach the 6 guides and 2 claws and remove the steering pad switch assembly.

NOTICE:

Detach the 2 guides on the upper part of the steering pad switch assembly first.

    Installation

    Stereo Component Amplifier

    See More:

    Toyota Tundra Service Manual > Differential Carrier Oil Seal(for 1ur-fe): Replacement
    REPLACEMENT PROCEDURE 1. DRAIN DIFFERENTIAL OIL 2. REMOVE PROPELLER SHAFT ASSEMBLY (a) Remove the propeller shaft for 2WD (See page ). (b) Remove the propeller shaft for 4WD (See page ). 3. REMOVE REAR DRIVE PINION NUT (a) Using SST and a hammer, loosen the staked part of the nut. SST: 09930-00010 ( ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0337