Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

3. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

(a) for Column Shift Type:

(See page )

(b) for Floor Shift Type:

(See page )

4. REMOVE NO. 2 HEATER TO REGISTER DUCT

5. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

6. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

7. REMOVE DEFROSTER NOZZLE ASSEMBLY

8. REMOVE NAVIGATION ANTENNA ASSEMBLY

(a) Detach the 2 clamps.

Text in Illustration

*a

Guide

*b

Clamp

(b) Remove the 2 screws.

(c) Detach the 2 guides and remove the navigation antenna assembly.

    Installation

    Navigation Receiver(for Column Shift Type)

    See More:

    Toyota Tundra Service Manual > Power Mirror Control System(w/ Memory): Power Mirror Surface Position is not Memorized
    DESCRIPTION When the seat memory switch is operated, the switch input signal is sent via CAN communication from the outer mirror control ECU assembly LH to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) then sends the memorization request or recall req ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0106