DESCRIPTION
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary. PROCEDURE
(a) Clear the DTCs (See page ). (b) Check for DTCs (See page ). OK: No DTCs are output.
(a) Disconnect the K1 and L1 navigation receiver assembly connectors. (b) Disconnect the K2 and L3 stereo component tuner assembly connector. (c) Measure the resistance according to the value(s) in the table below. Standard Resistance:
(a) Replace the No. 1 navigation wire with a known good one. for Column Shift Type: See page for Floor Shift Type: See page (b) Clear the DTCs (See page ). (c) Check for DTCs (See page ). OK: No DTCs are output.
(a) Replace the stereo component tuner assembly with a known good one. for Column Shift Type: See page for Floor Shift Type: See page (b) Clear the DTCs (See page ). (c) Check for DTCs (See page ). OK: No DTCs are output. Result
|
Toyota Tundra Service Manual > Millimeter Wave Radar Sensor: Removal
REMOVAL PROCEDURE 1. REMOVE RADIATOR GRILLE Click here 2. REMOVE MILLIMETER WAVE RADAR WIRE (a) for Type A: (1) Disconnect the connector. (2) Using a clip remover, detach the 3 clamps and remove the millimeter wave radar wire. (b) for Type B: (1) Disconnect the connector. (2) Using a clip remover, d ...