Toyota Tundra Service Manual: Disc cannot be Ejected

Toyota Tundra Service Manual / Audio, Visual, Telematics / Navigation / Multi Info Display / Navigation System / Disc cannot be Ejected

PROCEDURE

1.

PRESS "EJECT" AND CHECK OPERATION

(a) Press the disc eject switch of the navigation receiver assembly for 2 seconds or more and check that the disc is ejected.

OK:

Disc is ejected.

Result

Result

Proceed to

OK

A

NG (for Column Shift Type)

B

NG (for Floor Shift Type)

C
B

REPLACE NAVIGATION RECEIVER ASSEMBLY

C

REPLACE NAVIGATION RECEIVER ASSEMBLY

A

2.

REPLACE DISC WITH ANOTHER AND RECHECK

(a) Replace the disc with a known good one and check that the malfunction disappears.

OK:

Disc is ejected.

Result

Result

Proceed to

OK

A

NG (for Column Shift Type)

B

NG (for Floor Shift Type)

C
A

END (DISC IS DEFECTIVE)
B

REPLACE NAVIGATION RECEIVER ASSEMBLY

C

REPLACE NAVIGATION RECEIVER ASSEMBLY

    Diagnostic Trouble Code Chart

    Disc cannot be Inserted or is Ejected Right After Insertion

    See More:

    Toyota Tundra Service Manual > Sfi System: Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P0051,P0052,P101D,P103D)
    DESCRIPTION Refer to DTC P2195 (See page ). HINT: Although the DTC titles say oxygen sensor, these DTCs relate to the Air-Fuel Ratio (A/F) sensor. Sensor 1 refers to the sensor mounted in front of the Three-Way Catalytic Converter (TWC) and located near the engine assembly. When one of these DTCs is ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.01