Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

Avoid any impact to the blind spot monitor sensor.
Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

PROCEDURE

1. REMOVE REAR BUMPER COVER

Click here

2. REMOVE REAR BUMPER PLATE LH

Click here

3. REMOVE REAR BUMPER PLATE RH

HINT:

Use the same procedure described for the LH side.

4. REMOVE REAR BUMPER PAD SUB-ASSEMBLY LH

Click here

5. REMOVE REAR BUMPER EXTENSION INSERT LH

Click here

6. REMOVE REAR BUMPER EXTENSION INSERT RH

Click here

7. REMOVE BLIND SPOT MONITOR SENSOR LH

(a) Disconnect the connector and detach the wire harness clamp.

(b) Remove the 3 nuts and blind spot monitor sensor LH.

Text in Illustration

	Nut
	Connector

8. REMOVE BLIND SPOT MONITOR SENSOR RH

HINT:

Use the same procedure described for the LH side.

9. REMOVE BLIND SPOT MONITOR BRACKET LH

(a) Remove the 3 nuts and blind spot monitor bracket LH.

10. REMOVE BLIND SPOT MONITOR BRACKET RH

HINT:

Use the same procedure described for the LH side.

Toyota Tundra Service Manual > Lane Departure Alert System: Lost Communication with Yaw Rate Sensor Module (U0123,U0126,U0129,U0142,U0155)
DESCRIPTION These DTCs are output when a communication malfunction occurs between the sensors and ECUs. DTC No. Detection Item DTC Detection Condition Trouble Area U0123 Lost Communication with Yaw Rate Sensor Module 3 seconds after the ignition switch is turned to ON, the vehicle is being driven at ...

Toyota Tundra Owners Manual