DESCRIPTION The blind spot monitor sensor receives yaw rate signals from the yaw rate sensor via CAN communication.
CAUTION / NOTICE / HINT NOTICE: When checking for DTCs, make sure that the blind spot monitor system is turned on. PROCEDURE
(a) Check for vehicle stability control system DTCs. Click here OK: Vehicle stability control system DTCs are not output.
(a) Clear the DTCs. Click here (b) Recheck for DTCs and check if the same DTC is output again. Click here
|
Toyota Tundra Service Manual > Headlight Leveling Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT HEADLIGHT LEVELING SWITCH (a) Check the voltage. (1) Connect the battery positive (+) lead to terminal 1 (B) and the negative (-) lead to terminal 5 (E). (2) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Switch C ...