DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
PROCEDURE
(a) Change the blind spot monitor sensor RH to Test Mode using the Techstream. HINT: Refer to Blind Spot Monitor Beam Axis Inspection (See page
|
Toyota Tundra Service Manual > Lighting: Footwell Light
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL FOOT LIGHT BULB (a) Install the foot light bulb. Removal REMOVAL PROCEDURE 1. REMOVE FOOT LIGHT BULB (a) Remove the foot light bulb. ...
