DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
PROCEDURE
(a) Change the blind spot monitor sensor LH to Test Mode using the Techstream. HINT: Refer to Blind Spot Monitor Beam Axis Inspection (See page
|
Toyota Tundra Service Manual > Theft Deterrent System: Customize Parameters
CUSTOMIZE PARAMETERS PROCEDURE 1. CUSTOMIZE THEFT DETERRENT SYSTEM NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure to make a note of the current settings before customizing. When troubleshooting a function, first make sure that ...