DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis. HINT:
CAUTION / NOTICE / HINT NOTICE:
PROCEDURE
(a) Check the condition of the rear bumper around the blind spot monitor sensors. HINT: When mud, snow, ice, a sticker, etc. is covering the sensor or its surrounding area on the rear bumper, the blind spot monitor sensor may store this DTC by mistake.
(a) Clean the rear bumper. (b) Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream. Click here NOTICE: Before replacing the blind spot monitor sensor RH, visually check for damage to the stud bolts or area surrounding the blind spot monitor sensor RH. If there is any damage to the stud bolts or area surrounding the blind spot monitor sensor RH, perform Blind Spot Monitor Sensor Installation Condition Inspection and adjust according to the result.
(a) Check the installation condition of the blind spot monitor sensor RH. Click here OK: The blind spot monitor installation position is within the specified range
(a) Adjust the installation position of the blind spot monitor sensor RH. Click here
(a) Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream. Click here
|
Toyota Tundra Service Manual > Vehicle Stability Control System: Center Differential Lock Circuit (C1340)
DESCRIPTION The skid control ECU monitors the 2WD/4WD state from both the 4 wheel drive control ECU and the A.D.D. detection switch. DTC No. Detection Item DTC Detection Condition Trouble Area C1340 Center Differential Lock Circuit On a 4WD vehicle, a normal A.D.D. detection switch signal is input v ...