DESCRIPTION This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.
CAUTION / NOTICE / HINT NOTICE: When checking for DTCs, make sure that the blind spot monitor system is turned on. PROCEDURE
(a) Check the main body ECU (multiplex network body ECU) part number. (1) Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct. OK: The part number is correct.
(a) Clear the DTCs (See page
(b) Recheck for DTCs and check if the same DTC is output again. Click here
|
Toyota Tundra Service Manual > Camshaft(for Bank 1): Removal
REMOVAL PROCEDURE 1. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY (a) Remove the timing chain cover (See page ). 2. SET NO. 1 CYLINDER TO TDC / COMPRESSION 3. REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY LH (a) Move the stopper plate upward to release the lock, and push the plunger deep into the tensioner. (b) M ...
).
