Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Audio, Visual, Telematics / Park Assist / Monitoring / Clearance Sonar Main Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

7 (IG) - 8 (SK)

Sonar switch off

10 kΩ or higher

Sonar switch on

Below 1 Ω

If the result is not as specified, replace the back sonar or clearance sonar switch assembly.

(b) Check that the switch illuminates.

OK:

Tester Connection

Specified Condition

Battery positive (+) → Terminal 1 (ILL+)

Battery negative (-) → Terminal 6 (ILL-)

Illuminates

If the result is not as specified, replace the back sonar or clearance sonar switch assembly.

Text in Illustration

*a

Component without harness connected

(Back Sonar or Clearance Sonar Switch Assembly)
    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Pre-collision System: Vehicle Information Not Obtained (C1A02)
    DESCRIPTION When a new millimeter wave radar sensor assembly is installed, it receives vehicle specification information from the main body ECU (multiplex network body ECU) and stores the information. DTC C1A02 is stored when the millimeter wave radar sensor assembly receives the vehicle specificati ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0336