Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

(a) Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

4. REMOVE LOWER INSTRUMENT PANEL

5. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

6. REMOVE NO.4 INSTRUMENT REGISTER SUB-ASSEMBLY

7. REMOVE INSTRUMENT SIDE PANEL RH

8. REMOVE NO.2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

10. REMOVE CLEARANCE WARNING ECU WITH BRACKET

(a) Disconnect the ECU connectors and detach the harness clamp. NOTICE: Do not apply excessive force to the wire harnesses.

(b) Remove the bolt, nut and clearance warning ECU with bracket.

11. REMOVE CLEARANCE WARNING ECU ASSEMBLY

(a) Remove the 2 nuts and clearance warning ECU assembly from the bracket. NOTICE: Avoid any impact to the clearance warning ECU assembly. Do not drop the ECU. If it is dropped, replace it with a new one.