INSTALLATION PROCEDURE 1. INSTALL BLIND SPOT MONITOR BUZZER (a) Attach the clamp to install the blind spot monitor buzzer. (b) Connect the connector. 2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH
3. INSTALL LOWER QUARTER PANEL ASSEMBLY LH 4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH 5. INSTALL REAR DOOR SCUFF PLATE LH 6. INSTALL REAR SEAT ASSEMBLY
7. INSTALL SEAT FLOOR BOX
8. INSTALL LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH 9. INSTALL LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH |
Toyota Tundra Service Manual > Sfi System: Manifold Absolute Pressure / Barometric Pressure Circuit Low Input (P0107,P0108)
DESCRIPTION By a built-in sensor unit, the manifold absolute pressure sensor detects the intake manifold pressure as a voltage. DTC No. DTC Detection Condition Trouble Area P0107 The manifold absolute pressure sensor voltage is below 0.5 V for 0.5 seconds. (1 trip detection logic) Open or short in m ...
