Toyota Tundra Owners Manual: Engine (ignition) switch

Toyota Tundra Owners Manual / Driving / Driving procedures / Engine (ignition) switch

Starting the engine

1. Check that the parking brake is set.

2. Check that the shift lever is set in P.

3. Firmly depress the brake pedal.

4. Turn the engine switch to the "START" position to start the engine.

Changing the engine switch positions

"LOCK"
The steering wheel is locked and the key can be removed. (The key can be removed only when the shift lever is in P.)
"ACC"
Some electrical components such as the audio system can be used.
"ON"
All electrical components can be used.
"START"
For starting the engine.

Driving procedures

■Turning the key from "ACC" to "LOCK"

1. Shift the shift lever to P.

2. Push in the key and turn it to the "LOCK" position.

Driving procedures

■If the engine does not start The engine immobilizer system may not have been deactivated.

Contact your Toyota dealer.

■When the steering lock cannot be released When starting the engine, the engine switch may seem stuck in the "LOCK" position. To free it, turn the key while turning the steering wheel slightly left and right.

Driving procedures

■Key reminder function A buzzer sounds if the driver's door is opened while the engine switch is in the "ACC" or "LOCK" position to remind you to remove the key.

WARNING

■When starting the engine Always start the engine while sitting in the driver's seat. Do not depress the accelerator pedal while starting the engine under any circumstances.

Doing so may cause an accident resulting in death or serious injury.

■Caution while driving Do not turn the engine switch to the "LOCK" position while driving. If, in an emergency, you must turn the engine off while the vehicle is moving, turn the engine switch only to the "ACC" position to stop the engine. An accident may result if the engine is stopped while driving.

NOTICE

■To prevent battery discharge Do not leave the engine switch in the "ACC" or "ON" position for long periods of time without the engine running.

■When starting the engine

Do not crank the engine for more than 30 seconds at a time. This may overheat the starter and wiring system.
Do not race a cold engine.
If the engine becomes difficult to start or stalls frequently, have your vehicle checked by your Toyota dealer immediately.

Driving procedures

Automatic transmission

See More:

Toyota Tundra Service Manual > Can Communication System: Trailer Brake Controller Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Trailer Brake Controller Communication Stop Mode Any of the following conditions are met: Communication stop for "Trailer Brake Controller" is indicated on the "Communication Bus Check" screen of the Techstream. Communication system DTCs (DTCs that sta ...