Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Audio, Visual, Telematics / Park Assist / Monitoring / Ultrasonic Sensor(for Front Side) / Inspection

INSPECTION

PROCEDURE

1. INSPECT NO. 1 ULTRASONIC SENSOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (BI) - 5 (EI)

Always

10 kΩ or higher

1 (BI) - 2 (BO)

Always

10 kΩ or higher

3 (SI) - 4 (SO)

Always

Below 1 Ω

5 (EI) - 6 (EO)

Always

Below 1 Ω
Text in Illustration

*a

Component without harness connected:

(No. 1 Ultrasonic Sensor)

If the result is not as specified, replace the No. 1 ultrasonic sensor.
    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Starter(for 2.0 Kw Type): Installation
    INSTALLATION PROCEDURE 1. INSTALL STARTER ASSEMBLY (a) Install the flywheel housing side cover. (b) Install the starter with the 2 bolts. Torque: 37 N·m {377 kgf·cm, 27 ft·lbf} (c) Connect the starter wire with the nut. Torque: 9.8 N·m {100 kgf·cm, 87 in·lbf} (d) Connect the starter connector. ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0334