Toyota Tundra Service Manual: Installation

(a) Tighten the 3 nuts uniformly in alphabetical order.

NOTICE:

Do not drop the actuator. If dropped, replace it.

Torque:

22 N·m {224 kgf·cm, 16 ft·lbf}

(b) Set each brake line to the correct position on the brake actuator as shown in the illustration.

HINT:

• *1: FR RH
• *2: FR LH
• *3: RR RH
• *4: RR LH
• *5: FR Master Cylinder
• *6: RR Master Cylinder

(d) Using a union nut wrench, tighten the 2 brake tubes.

Torque:

Specified tightening torque :

19.5 N·m {199 kgf·cm, 14 ft·lbf}

HINT:

• Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

  Click here

• When using a union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 17.6 N*m (179 kgf*cm, 13 ft.*lbf)

(e) Using a union nut wrench, tighten the 4 brake tubes.

Torque:

Specified tightening torque :

15.2 N·m {155 kgf·cm, 11 ft·lbf}

HINT:

• Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

  Click here

• When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.378 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)

(f) Connect the connector.