INSTALLATION PROCEDURE 1. INSTALL STEERING ANGLE SENSOR 2. INSTALL SPIRAL CABLE SUB-ASSEMBLY 3. INSTALL UPPER STEERING COLUMN COVER 4. INSTALL LOWER STEERING COLUMN COVER 5. ADJUST SPIRAL CABLE 6. INSTALL STEERING WHEEL ASSEMBLY 7. INSTALL STEERING PAD 8. INSTALL LOWER NO. 3 STEERING WHEEL COVER 9. INSTALL LOWER NO. 2 STEERING WHEEL COVER 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 11. CHECK SRS WARNING LIGHT (a) Check the SRS warning light (See page
|
Toyota Tundra Service Manual > Brake Actuator: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CONNECT TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Start the engine and run it at idle. (c) Select the Active Test mode on the Techstream. HINT: Refer to the Techstream operator's manual for further details. 2. INSPECT ACTUATOR MOTOR OPERATION (a) With ...
