Toyota Tundra Service Manual: Stop Light Control Relay

Toyota Tundra Service Manual / Brake / Brake Control / Dynamic Control Systems / Stop Light Control Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK STOP LIGHT CONTROL RELAY

(a) Remove the stop light control relays (BRK NO. 1) from the engine room relay block.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

for BRK NO. 1

Tester Connection	Condition	Specified Condition
3 - 4	When battery voltage is not applied to terminals 1 and 2	10 kΩ or higher
3 - 5	When battery voltage is not applied to terminals 1 and 2	Below 1 Ω
3 - 4	When battery voltage is applied to terminals 1 and 2	10 kΩ or higher
3 - 5	When battery voltage is applied to terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the relay.

See More:

Toyota Tundra Service Manual > Key Reminder Warning System: Operation Check
OPERATION CHECK 1. CHECK KEY REMINDER WARNING SYSTEM (a) Check that the key reminder warning buzzer sounds. (1) With the driver side door closed, insert the key into the ignition key cylinder and then turn the key to the LOCK or ACC position. (2) Check that the buzzer sounds intermittently if the dr ...

Toyota Tundra Service Manual: Stop Light Control Relay

Removal

Trailer Brake Control Ecu

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual