Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL TRAILER BRAKE CONTROL ECU (BRAKE CONTROL WITH BRACKET RELAY)

(a) Connect the 2 connectors to the trailer brake control ECU (brake control with bracket relay).

(b) install the trailer brake control ECU (brake control with bracket relay) with the 2 nuts.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

2. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Click here

3. INSTALL LOWER INSTRUMENT PANEL

Click here

4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

5. INSTALL INSTRUMENT SIDE PANEL RH

Click here

6. INSTALL COWL SIDE TRIM BOARD RH

Click here

7. INSTALL FRONT DOOR SCUFF PLATE RH

Click here

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

9. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

10. CHECK SRS WARNING LIGHT

Click here

    Components

    Removal

    See More:

    Toyota Tundra Service Manual > Shift Lever Assembly(for Column Shift Type): Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL TRANSMISSION CONTROL SWITCH (P POSITION) (a) Install the switch to the column shift control shift lever retainer with the 2 screws. 2. INSTALL TRANSMISSION CONTROL SWITCH (S POSITION) (a) Apply MP grease to the switch as shown in the illustration. (b) Install the swit ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0329