Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

• When replacing the brake control with bracket relay, the stored gain value is reset.
• Before replacing the brake control with bracket relay, record the set gain value.

HINT:

After replacing the brake control with bracket relay, the gain value is set to 5.0 (initial value).

PROCEDURE

1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

3. REMOVE FRONT DOOR SCUFF PLATE RH

Click here

4. REMOVE COWL SIDE TRIM BOARD RH

Click here

5. INSTALL INSTRUMENT SIDE PANEL RH

Click here

6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

Click here

7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

8. REMOVE LOWER INSTRUMENT PANEL

Click here

9. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Click here

10. REMOVE TRAILER BRAKE CONTROL ECU (BRAKE CONTROL WITH BRACKET RELAY)

(a) Disconnect the 2 connectors.

(b) Remove the 2 bolts and trailer brake control ECU (brake control with bracket relay).