INSTALLATION PROCEDURE 1. INSTALL TRAILER BRAKE CONTROL ECU (BRAKE CONTROL WITH BRACKET RELAY) (a) Connect the connector. (b) Install the trailer brake control switch with the 2 bolts. Torque: xx N*m (xx kgf*cm, xx in.*lbf) 2. INSTALL NO. 2 SWITCH HOLE BASE 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH 4. INSTALL COWL SIDE TRIM BOARD LH 5. INSTALL FRONT DOOR SCUFF PLATE LH
6. INSTALL INSTRUMENT SIDE PANEL LH
|
Toyota Tundra Service Manual > Maintenance: Inside Vehicle
General MaintenanceGENERAL MAINTENANCE CAUTION / NOTICE / HINT Performing the following maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In ...
