Toyota Tundra Owners Manual: Windshield wipers and washer

Operating the wiper lever

The wipers or washer operates by operating the lever as follows:

Vehicles without intermittent type

  1. (U.S.A.) or (Canada) Off

  2. (U.S.A.) or (Canada) Low speed windshield wiper operation

  3.   (U.S.A.) or (Canada) High speed windshield wiper operation

  4. (U.S.A.) or (Canada) Temporary operation

Operating the lights and wipers

  1. Washer operation

Pulling the lever towards you operate the washer.

Operating the lights and wipers

Vehicles with intermittent type

  1. (U.S.A.) or (Canada) Off

  2. (U.S.A.) or (Canada) Intermittent windshield wiper operation

  3. (U.S.A.) or (Canada) Low speed windshield wiper operation

  4. (U.S.A.) or (Canada) High speed windshield wiper operation

  5. (U.S.A.) or (Canada) Temporary operation

Operating the lights and wipers

Wiper intervals can be adjusted when intermittent operation is selected.

  1. Increases the intermittent windshield wiper frequency
  2. Decreases the intermittent windshield wiper frequency

Operating the lights and wipers

  1. Washer/wiper dual operation

Pulling the lever towards you operates the wipers and washer.

Wipers will automatically operate a couple of times after the washer squirts.

Operating the lights and wipers

■The windshield wipers and washer can be operated when The engine switch is in the "ON" position.

■If no windshield washer fluid sprays Check that the washer nozzles are not blocked if there is washer fluid in the windshield washer fluid reservoir.

WARNING

■Caution regarding the use of washer fluid When it is cold, do not use the washer fluid until the windshield becomes warm. The fluid may freeze on the windshield and cause low visibility. This may lead to an accident, resulting in death or serious injury.

 

NOTICE

■When the windshield is dry Do not use the wipers, as they may damage the windshield.

■When the washer fluid tank is empty Do not operate the switch continually as the washer fluid pump may overheat.

■When a nozzle becomes blocked In this case, contact your Toyota dealer.

Do not try to clear it with a pin or other object. The nozzle will be damaged.

    Automatic High Beam

    Refueling

    See More:

    Toyota Tundra Service Manual > Trailer Brake Control System: Gain Rocker Switch (+) Circuit (C14A1,C14A2)
    DESCRIPTION DTC No. Detection Item INF Code DTC Detection Condition Trouble Area C14A1 Gain Rocker Switch (+) Circuit 21 With the ignition switch turned to ON and the IG terminal voltage from 11 to 14 V, an open circuit occurs continuously in the GAIN (+) selection button internal circuit or wire ha ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0672