DESCRIPTION The skid control ECU (brake actuator assembly) sends a stop light operation request signal to the stop light control relay. If the skid control ECU (brake actuator assembly) detects a malfunction in the stop light control relay circuit, the trailer brake control ECU (brake control with bracket relay) stores DTC C1380.
CAUTION / NOTICE / HINT NOTICE: The trailer brake control system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting. Click here
PROCEDURE
HINT: Trailer brake control system DTC C1380 may be stored due to a malfunction in the vehicle stability control system. Therefore, it is necessary to check for and troubleshoot vehicle stability control system DTCs first. (a) Check for DTCs. Click here
(a) Clear the DTCs. Click here (b) Turn the ignition switch off. (c) Turn the ignition switch to ON. (d) Check if the same DTC is output. Click here
|
Toyota Tundra Service Manual > Sfi System: Secondary Air Injection System Pump Stuck On Bank1 (P2444-P2447)
DESCRIPTION Refer to P2440 (See page ). DTC No. DTC Detection Condition Trouble Area P2444 P2446 Secondary air pressure more than 3.0 kPa (23 mmHg) despite ECM commanding air pump to turn off (2 trip detection logic) Short in air pump circuit Open or short in pressure sensor circuit Pressure sensor ...
