DTC CHECK / CLEAR 1. DTC CHECK/CLEAR (a) Check for DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream on. (4) Read the DTCs following the prompts on the Techstream. Enter the following menus: Chassis / Trailer Brake Controller / Trouble Codes. (b) Clear the DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream on. (4) Operate the Techstream to clear the codes. Enter the following menus: Chassis / Trailer Brake Controller / Trouble Codes. (5) According to the display on the Techstream, select the trouble code data display with the clear button. |
Toyota Tundra Service Manual > Front Door Lock(for Crewmax): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH 2. ...
