Toyota Tundra Service Manual: ABS Warning Light does not Come ON

Toyota Tundra Service Manual / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / ABS Warning Light does not Come ON

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration.

Click here

PROCEDURE

1.

CHECK CAN COMMUNICATION SYSTEM

(a) Check if CAN communication system DTCs are output.

Click here

Result

Proceed to

DTCs are not output

A

DTCs are output

B
B

INSPECT CAN COMMUNICATION SYSTEM

A

2.

PERFORM ACTIVE TEST USING TECHSTREAM (ABS WARNING LIGHT)

(a) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.

ABS/VSC/TRAC

Tester Display

Measurement Item

Control Range

Diagnostic Note

ABS Warning Light

ABS warning light

Warning light OFF/ON

Observe combination meter assembly
ABS/VSC/TRAC

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

ABS Warning Light

ABS warning light

ON or OFF

ON: Warning light on

OFF: Warning light off

-

(b) Check the operating condition of the ABS warning light when operating it using the Techstream.

Result

Proceed to

ABS warning light in the Data List does not change using the Active Test

A

ABS warning light in the Data List turns ON/OFF using the Active Test

B
A

REPLACE BRAKE ACTUATOR ASSEMBLY

B

3.

INSPECT COMBINATION METER ASSEMBLY

(a) Enter the following menus: Body Electrical / Combination Meter / Active Test.

Click here

(b) Perform the Active Test of the combination meter assembly using the Techstream.

(c) Check the combination meter assembly.

OK:

The ABS warning light turns on or off in accordance with the Techstream operation.

OK

REPLACE BRAKE ACTUATOR ASSEMBLY

NG

INSPECT METER / GAUGE SYSTEM

    ABS Operates Before Necessary When Braking

    ABS Warning Light Remains ON

    See More:

    Toyota Tundra Service Manual > Meter / Gauge System: Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Meter/gauge system: DTC Code Detection Item See page B1500 Fuel Sender Open Detected B1507 Open i ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0119