Toyota Tundra Service Manual: Brake Actuator Operation Sound is Loud during Initial Check

Toyota Tundra Service Manual / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / Brake Actuator Operation Sound is Loud during Initial Check

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration.

Click here

PROCEDURE

1.

PERFORM ROAD TEST

(a) After turning the ignition switch to ON, compare the operating sound of the brake actuator the first time the vehicle speed reaches 9 km/h (6 mph) with a known good vehicle of the same model.

OK:

The operating sound is the same or quieter than that of a known good vehicle of the same model.

HINT:

When the vehicle speed reaches approximately 9 km/h (6 mph), the initial check of the brake actuator assembly is performed and pump motor operation sounds are generated.

OK

END

NG

2.

CHECK BRAKE ACTUATOR BOLT CUSHION

(a) Check that the cushion of the brake actuator bracket assembly is not worn, damaged or deformed.

OK:

The brake actuator bracket assembly is not worn, damaged or deformed.

NG

REPLACE BRAKE ACTUATOR BRACKET ASSEMBLY

OK

3.

ADJUST INSTALLATION OF BRAKE ACTUATOR ASSEMBLY

(a) Drain the brake fluid.

(b) Disconnect all brake lines from the brake actuator assembly.

Click here

(c) Connect each brake line so that the cushion of the brake actuator assembly is tensioned evenly.

Click here

NOTICE:

After connecting all the brake lines, add brake fluid and bleed the brake system.

Click here

HINT:

By reducing the tension on the brake lines and cushion, the operating sound of the brake actuator assembly may be reduced.

(d) Check that no brake lines interfere the vehicle body or other components.

NEXT

4.

RECHECK SYMPTOM

(a) Perform a road test and check the magnitude of the operating sound again.

OK:

The operating sound is the same or quieter than that of a known good vehicle of the same model.

OK

END

NG

REPLACE BRAKE ACTUATOR ASSEMBLY

    ABS Warning Light Remains ON

    Brake Warning Light does not Come ON

    See More:

    Toyota Tundra Service Manual > Rear View Monitor System(for Navigation Receiver Type): Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Rear View Monitor System DTC Code Detection Item See page C1622 Open or Short Circuit in Back Camera Signal ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0173