Toyota Tundra Service Manual: Brake Warning Light does not Come ON

Toyota Tundra Service Manual / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / Brake Warning Light does not Come ON

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration zero point calibration.

    Click here

  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.

CHECK CAN COMMUNICATION SYSTEM

(a) Check if CAN communication system DTCs are output.

Click here

Result

Proceed to

DTCs are not output

A

DTCs are output

B
B

INSPECT CAN COMMUNICATION SYSTEM

A

2.

PERFORM ACTIVE TEST USING TECHSTREAM (BRAKE WARNING LIGHT)

(a) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.

ABS/VSC/TRAC

Tester Display

Measurement Item

Control Range

Diagnostic Note

Brake Warning Light

Brake warning light

Warning light OFF/ON

Observe combination meter assembly
ABS/VSC/TRAC

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Brake Warning Light

Brake warning light

ON or OFF

ON: Warning light on

OFF: Warning light off

-

(b) Check the operating condition of the brake warning light when operating it using the Techstream.

Result

Proceed to

Brake warning light in the Data List does not change using the Active Test

A

Brake warning light in the Data List turns ON/OFF using the Active Test

B
A

REPLACE BRAKE ACTUATOR ASSEMBLY

B

3.

INSPECT COMBINATION METER ASSEMBLY

(a) Enter the following menus: Body Electrical / Combination Meter / Active Test.

Click here

(b) Perform the Active Test of the combination meter assembly using the Techstream.

(c) Check the combination meter assembly.

OK:

The brake warning light turns on or off in accordance with the Techstream operation.

OK

REPLACE BRAKE ACTUATOR ASSEMBLY

NG

INSPECT METER / GAUGE SYSTEM

    Brake Actuator Operation Sound is Loud during Initial Check

    Brake Warning Light Remains ON

    See More:

    Toyota Tundra Service Manual > Automatic Transmission Unit: Components
    COMPONENTS ILLUSTRATION *1 AUTOMATIC TRANSMISSION BREATHER TUBE *2 AUTOMATIC TRANSMISSION HOUSING *3 EXTENSION HOUSING DUST DEFLECTOR *4 EXTENSION HOUSING REAR OIL SEAL *5 EXTENSION HOUSING SUB-ASSEMBLY *6 OIL COOLER TUBE UNION *7 PARK/NEUTRAL POSITION SWITCH ASSEMBLY *8 TRANSMISSION CONTROL SHAFT L ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0113