DESCRIPTION The skid control ECU (brake actuator assembly) stores this DTC if malfunctions are found in a circuit inside the ECU by self diagnosis.
CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration. Click here
PROCEDURE
(a) Replace the skid control ECU (brake actuator assembly). Click here HINT: This DTC is output when the skid control ECU (brake actuator assembly) detects a malfunction in an internal circuit.
|
Toyota Tundra Service Manual > Propeller Shaft Assembly(for 4wd): Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING HINT: Use the same installation procedure for both the front and rear propeller shaft universal joint spider bearings. (a) Apply MP grease to a new spider and 4 new bearings. NOTICE: Be careful not to apply too much ...
