Toyota Tundra Service Manual: Steering Angle Sensor Internal Circuit (C1433)

Toyota Tundra Service Manual / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / Steering Angle Sensor Internal Circuit (C1433)

DESCRIPTION

This DTC is stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the steering angle sensor (spiral with sensor cable sub-assembly).

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1433

Steering Angle Sensor Internal Circuit

With the +BS terminal voltage between 9.6 and 16.5 V, a steering angle sensor malfunction signal is received from the steering angle sensor.

Steering angle sensor (spiral with sensor cable sub-assembly)

PROCEDURE

1.

REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

(a) Replace the steering angle sensor (spiral with sensor cable sub-assembly).

Click here

NEXT

END
    Steering Angle Sensor Power Source Voltage Malfunction (C1432)

    Steering Angle Sensor Output Malfunction (C1434)

    See More:

    Toyota Tundra Service Manual > Theft Warning Ecu: Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart. Click here PROCEDURE 1. INSTALL GLASS BREAKAGE SENSOR ECU (a) Install the glass breakage sensor ECU with the nut. Torque: 7.6 N·m {77 kgf·cm, 67 in·lbf} (b) Install the junction b ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0343