DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration. Click here PROCEDURE
(a) Check if CAN communication system DTCs are output. Click here
(a) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test. ABS/VSC/TRAC
(b) Check the operating condition of the slip indicator light when operating it using the Techstream.
(a) Enter the following menus: Body Electrical / Combination Meter / Active Test. Click here (b) Perform an Active Test of the combination meter assembly using the Techstream. (c) Check the combination meter assembly. OK: The slip indicator light turns on or off in accordance with the Techstream operation.
|
Toyota Tundra Service Manual > Lighting System: Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or ...