Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT BRAKE PEDAL LOAD SENSING SWITCH

HINT:

Do not remove the brake pedal load sensing switch from the brake pedal support assembly.
When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support assembly.

(a) Disconnect the brake pedal load sensing switch connector.

Text in Illustration

*1	Brake Pedal Load Sensing Switch	-	-
*a	Brake pedal released (ON)	*b	Brake pedal depressed (OFF)

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
2 (FSW+) - 1 (FSW-)	Brake pedal depressed	900 to 1100 Ω
2 (FSW+) - 1 (FSW-)	Brake pedal released	192 to 234 Ω

Toyota Tundra Service Manual > Dynamic Radar Cruise Control System: Vehicle Information Not Obtained (C1A02)
DESCRIPTION When a new millimeter wave radar sensor assembly is installed, it receives vehicle specification information (destination, steering wheel position, 2WD or 4WD, etc.) from the main body ECU (multiplex network body ECU) and stores the information. DTC C1A02 is stored when the millimeter wa ...

Toyota Tundra Owners Manual