REMOVAL PROCEDURE 1. REMOVE PRECAUTION NOTICE: After turning the ignition switch off, waiting time be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ). 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable some systems need to be initialized after the cable is reconnected. Click here 3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Click here 4. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY
5. REMOVE PUSH ROD PIN (a) Remove the clip and push rod pin. 6. REMOVE STOP LIGHT SWITCH ASSEMBLY
7. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER (a) Remove the stop light switch mounting adjuster. 8. DISCONNECT BRAKE PEDAL SUPPORT ASSEMBLY
(b) Disconnect the 2 clamps from the brake pedal support assembly.
(f) Remove the bolt, and disconnect the brake pedal support assembly from the instrument panel reinforcement assembly. 9. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY Click here 10. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
11. REMOVE BRAKE PEDAL PAD (a) Remove the brake pedal pad. |
Toyota Tundra Service Manual > Thermostat: Installation
INSTALLATION PROCEDURE 1. INSTALL WATER INLET SUB-ASSEMBLY WITH THERMOSTAT (a) Install a new gasket and the water inlet with thermostat with the 3 nuts. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. CONNECT OUTLET RADIATOR HOSE (a) Connect the radiator hose. HINT: The direction of hose clamp is indica ...