Toyota Tundra Service Manual: Front Brake Flexible Hose

Components

COMPONENTS

ILLUSTRATION

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

PROCEDURE

1. INSTALL FRONT FLEXIBLE HOSE

(a) Attach 2 new clips (labeled A) to the flexible hose.

(b) Using a union nut wrench, connect the flexible hose to the brake tube and wheel cylinder tube while holding the flexible hose with a wrench.

Torque:

15 N·m {155 kgf·cm, 11 ft·lbf}

NOTICE:

• Do not bend or damage the brake tube and wheel cylinder tube.
• Do not allow any foreign matter such as dirt and dust to enter the brake tube and wheel cylinder tube from the connecting points.
• Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page ).

2. BLEED BRAKE LINE

3. INSTALL FRONT WHEEL

Torque:

for Aluminum Wheel :

131 N·m {1336 kgf·cm, 97 ft·lbf}

for Steel Wheel :

209 N·m {2131 kgf·cm, 154 ft·lbf}

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

PROCEDURE

1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.

3. REMOVE FRONT FLEXIBLE HOSE

(a) Remove the brake tube and wheel cylinder tube from the flexible hose with a union nut wrench while holding the flexible hose with a wrench.

NOTICE:

• Do not bend or damage the brake tube and wheel cylinder tube.
• Do not allow any foreign matter such as dirt and dust to enter the brake tube and wheel cylinder tube from the connecting points.

(b) Remove the 2 clips (labeled A) and flexible hose.