Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Brake / Brake / Front Brake / Inspection

INSPECTION

PROCEDURE

1. CHECK BRAKE CALIPER AND PISTON

(a) Check the caliper bore and piston for rust or scoring.

If necessary, replace the disc brake caliper assembly.

2. CHECK PAD LINING THICKNESS

(a) Using a ruler, measure the pad lining thickness.

Standard thickness:

11.9 mm (0.469 in.)

Minimum thickness:

1.0 mm (0.0394 in.)

If the pad lining thickness is less than the minimum, replace the pad.

HINT:

Be sure to check the wear on the front disc after replacing the brake pad with a new one.

3. CHECK FRONT DISC BRAKE ANTI-RATTLE SPRING

(a) Use brake cleaner to clean the front disc brake anti-rattle spring. Check for deformation and cracks.

(b) When installing the front disc brake anti-rattle spring to the front disc brake caliper, check that the spring's force is applied to the hole pin and brake pad.

4. CHECK DISC THICKNESS

(a) Using a micrometer, measure the disc thickness.

Standard thickness:

32.0 mm (1.26 in.)

Minimum thickness:

29.0 mm (1.14 in.)

If the disc thickness is less than the minimum, replace the disc.

5. CHECK DISC RUNOUT

(a) Tighten the disc with the 5 hub nuts.

Torque:

for Aluminum Wheel :

131 N·m {1336 kgf·cm, 97 ft·lbf}

for Steel Wheel :

209 N·m {2131 kgf·cm, 154 ft·lbf}

(b) Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the disc.

Maximum disc runout:

0.05 mm (0.00197 in.)

If the runout is more than the maximum, change the installation positions of the disc and axle so that the runout is as small as possible.

If the runout is more than the maximum even when the installation positions are changed, check the bearing looseness in the axial direction (See page ) and the axle hub runout (See page ).

If the bearing looseness and the axle hub runout are normal, and if the disc thickness is not within the specified range, grind the disc.

If the disc thickness is less than the minimum, replace the disc.

See More:

Toyota Tundra Service Manual > Vehicle Stability Control System: VSC does not Operate or VSC does not Operate Correctly
DESCRIPTION When TRAC or VSC is operating, the skid control ECU (brake actuator assembly) blinks the slip indicator light to inform the driver that slippage occurred. When a communication malfunction with the ECM is detected, TRAC and VSC are disabled. Also, TRAC and VSC are disabled when a DTC is s ...

Toyota Tundra Service Manual: Inspection

Disassembly

Installation

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual