Toyota Tundra Service Manual: Disassembly

Toyota Tundra Service Manual / Brake / Brake / Rear Brake / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

2. REMOVE REAR DISC BRAKE BLEEDER PLUG

3. REMOVE CYLINDER BOOT

(a) Using a screwdriver, remove the cylinder boot from the cylinder.

HINT:

Tape the screwdriver tip before use.

4. REMOVE REAR DISC BRAKE PISTON

(a) Place a piece of cloth or a similar object between the piston and cylinder.

(b) Use compressed air to remove the piston from the cylinder.

CAUTION:

Do not place your fingers in front of the piston when using compressed air.

5. REMOVE PISTON SEAL

(a) Using a screwdriver, remove the piston seal from the cylinder.

NOTICE:

Do not damage the inner cylinder or cylinder groove.

HINT:

Tape the screwdriver tip before use.

See More:

Toyota Tundra Service Manual > Fog Light Assembly(for Halogen Fog Light): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FOG LIGHT ASSEMBLY LH (a) Attach the 2 guides to install the fog light assembly LH. (b) Install the screw. 2. INSTALL FRONT BUMPER ASSEMBLY ( ...

Toyota Tundra Service Manual: Disassembly

Components

Inspection

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual