Toyota Tundra Service Manual: Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL PISTON SEAL

(a) Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of a new piston seal.

(b) Install the piston seal to the disc brake cylinder.

2. INSTALL CYLINDER BOOT

(a) Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of a new cylinder boot.

(b) Apply a light coat of lithium soap base glycol grease to the entire outer circumference of the rear disc brake piston where it contacts the rear disc brake cylinder.

(c) Install the cylinder boot to the rear disc brake piston.

(d) Install the rear disc brake piston to the rear disc brake cylinder assembly.

3. INSTALL REAR DISC BRAKE PISTON

(a) Install the cylinder boot to the disc brake cylinder.

NOTICE:

Install the boot securely into the groove of the disc brake cylinder.

(b) Push in the piston by hand and install the cylinder boot into the groove of the piston.

NOTICE:

Install the boot securely into the grooves of the piston.

4. INSTALL REAR DISC BRAKE BLEEDER PLUG

Torque:

11 N·m {110 kgf·cm, 8 ft·lbf}

5. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP

    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Theft Deterrent System: How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: Use these procedures to troubleshoot the theft deterrent system. *: Use the Techstream. Troubleshooting of the theft deterrent system is based on the premise that the door lock control system, the wireless door lock control system, the lighting system, the horn system, ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0309